-Start by thoroughly cleaning the application surfaces to remove any dirt, oil, blistered paint, and dust.

-Correct any surface defects with San Deco Acrylic Putty Interior.

-For painted surfaces, apply a coat of San Deco Decoprimer after diluting it with clean water at a volume of 20-25%.

-Apply two layers of diluted San Deco Decoprimer to the surface using a brush.

-Ensure that the surface is allowed to fully dry between each layer.

-It is advisable to incorporate Cometa product into gold-silver-bronze, or other varieties at a rate of 9-10%. If a lower flake intensity is desired, these ratios can be decreased accordingly.

-Following this, the Cometa product with Cometa added should be applied to the surface as outlined in its technical bulletin.

-Ensure that the temperature in the application environment remains within the range of +5°C to +35°C during and within 24 hours after the application.

The touch dry time is approximately 4-5 hours at 23°C, while complete drying is achieved within 24 hours at the same temperature.

For a single coat application, the coverage of the paint depends on factors such as surface smoothness, porosity, and the chosen application methods:

• 1 liter covers an area ranging from 7.5 to 9.5 m².
• 1 kilogram provides coverage for an area spanning from 6.5 to 8.5 m².
• The paint consumption per 1m² area falls within the range of 100-130 milliliters (ml) and 120-155 grams (g).

TDS

• DP.007.ENG_COMETA_TDS_ENG-2021.pdf

SDS

• COMETA_DEKA_BOYA_SDS_326088_Ver.3.0EN.pdf